How to Reset a Water Heater Pilot Light Safely
A safe, step-by-step guide to relighting your gas water heater pilot in Littleton, CO - plus the warning signs that mean it's time to call a licensed plumber.

You can safely reset a water heater pilot light by turning the gas control knob to OFF, waiting five minutes for residual gas to clear, setting the knob to PILOT, holding it down while you press the igniter, and holding for 30 to 60 seconds after the flame catches before releasing. If the pilot stays lit, turn the knob to ON and you have hot water again in about 30 minutes. If it goes out again within a few hours, the thermocouple, thermopile, or gas valve is usually the culprit - and that is a repair, not a reset.
This guide walks through the exact steps, the mistakes that cause most failed relights, and the point where a Littleton homeowner should stop and call a licensed plumber. We work on gas water heaters across Littleton every week, from 20-year-old tanks in Historic Downtown Littleton to newer units in Ken Caryl, and the same handful of problems cause almost every pilot light failure.
What a Water Heater Pilot Light Actually Does
The pilot light is a small standing flame that burns continuously at the base of a gas water heater. Its job is to ignite the main burner when the thermostat calls for heat. Without it, the burner never fires and the tank never warms - you get cold showers within a few hours.
How to reset water heater pilot light Littleton CO is a repair procedure that relights that standing flame and confirms the safety system is working. The safety system is the thermocouple or thermopile: a small metal probe sitting in the pilot flame. It generates a tiny electrical current - roughly 20 to 30 millivolts - that tells the gas valve "the flame is lit, keep the gas flowing." If the probe stops generating that current, the valve shuts off the gas. That is a safety feature, not a malfunction. It is the reason a dirty or worn thermocouple causes the pilot to die seconds after it lights.
Most residential gas water heaters in Littleton run on natural gas from Xcel Energy, though some rural properties around Roxborough and Chatfield use propane. The reset procedure is identical for both. What differs is the burner orifice and the gas pressure setting, which is why a propane unit that keeps losing its pilot should be checked by someone who works on propane appliances.
How Do I Reset My Water Heater Pilot Light in Littleton CO?
Resetting a gas water heater pilot in Littleton takes about 10 minutes if the thermocouple is healthy. Here is the sequence we use on every service call.
- Shut off the gas. Turn the control knob on top of the gas valve to OFF. Do not skip this. If the pilot went out mid-cycle, unburned gas may still be sitting in the combustion chamber.
- Wait five full minutes. This is the minimum clear-out time. We wait ten on older units. Use the time to open a nearby window or garage door if the heater sits in a tight utility closet.
- Check the combustion air openings. At the base of the tank there are small vents. If they are packed with dust, pet hair, or dryer lint, the pilot flame will be starved of oxygen and will not stay lit. Vacuum them out.
- Set the knob to PILOT. Push the knob in or turn it to the PILOT position, depending on your valve brand - Robertshaw, Honeywell, and White-Rodgers all use slightly different detents.
- Hold the knob down and press the igniter. On a piezo igniter, press the button repeatedly until you hear a click and see a flame through the sight glass. On older units with a match holder, light the match first, then hold it to the pilot port.
- Keep holding for 30 to 60 seconds after the flame catches. This is the step most homeowners rush. The thermocouple needs that time to heat up and generate enough current to hold the gas valve open.
- Release the knob slowly. If the flame stays lit, turn the knob to ON. If it dies the moment you release, the thermocouple is the problem - go back to step 1 and try once more, then stop.
- Set the thermostat. 120°F is the standard setting for a household with young kids or elderly residents. 130°F to 140°F gives you longer showers but raises scald risk.
You should have hot water back at the tap in 30 to 45 minutes for a 40-gallon tank, or closer to an hour for a 50-gallon unit in a cold Colorado garage.
Why Does My Water Heater Pilot Light Keep Going Out in Littleton?
A pilot light that keeps going out in Littleton almost always points to one of six causes, and the fix depends on which one you have.
- Failed thermocouple or thermopile. The most common cause by a wide margin. These probes wear out in 5 to 8 years. Replacement parts run $15 to $40; the labor is the real cost.
- Dirty pilot orifice. A tiny brass orifice feeds the pilot flame. Dust, rust flakes, and spider webs clog it. The flame burns yellow and weak instead of a crisp blue.
- Draft or backdraft. Littleton sits at 5,400 feet, and our wind patterns off the foothills push cold air down chimneys. A downdraft can blow out a pilot, especially on a unit with a short vent run.
- High-altitude combustion issues. At this elevation, gas appliances need slightly different air-to-fuel ratios. A unit that was never derated for altitude will run a weak, unstable pilot.
- Failing gas valve. When the valve itself is going, the pilot may light and then drop out randomly. This is a $250 to $450 repair on most residential tanks.
- Sediment and thermal stress. Littleton's water carries moderate mineral content. Over years, sediment builds on the tank floor and the burner runs hotter, cooking the thermocouple faster.
If your pilot light out Littleton CO situation repeats more than twice in a month, stop relighting it. You are masking a part that is about to fail completely, and the next failure will be at 6 a.m. on a Sunday.
Homeowners in older neighborhoods deal with this more than most. The housing stock in Historic Downtown Littleton Plumber Littleton CO includes a lot of water heaters pushing past their tenth year, and the venting in those basements was never designed for modern high-efficiency appliances. We see the same pattern in the 1960s and 70s builds around Ken Caryl Plumber Littleton CO, where original flue runs and settled foundations create draft problems that kill pilots every winter.
Is It Safe to Reset a Water Heater Pilot Light in Littleton?
Yes, resetting a pilot light is safe for a homeowner to do if you follow three rules: shut the gas off first, wait the full five minutes, and never relight a pilot when you smell gas. Those three rules cover the vast majority of residential gas water heater accidents.
What is not safe is relighting a pilot on a unit that has a cracked heat exchanger, a corroded flue, or a gas leak you cannot smell. Carbon monoxide is odorless. If anyone in the house has been getting headaches, nausea, or unusual drowsiness, shut the unit off at the gas valve and call us before you touch the igniter.
Here is the short safety checklist we give every homeowner:
- No gas smell before you start. If you smell rotten eggs, leave the house and call 911 or Xcel Energy's emergency line from outside.
- No standing water around the base of the tank. Water plus electricity plus gas is a call-a-pro situation.
- No scorch marks, soot, or melted wiring near the burner compartment.
- Working CO detector on every level of the home. Colorado law requires them in most residential rentals and it is good practice everywhere.
If any of those four items is off, do not reset the pilot. Call a licensed plumber. A failed thermocouple is a $150 to $250 repair. A carbon monoxide incident is not something you want to price out.
Common Mistakes We See Homeowners Make
We get called out on pilot light issues constantly, and the same mistakes show up over and over. Avoiding these will save you a service call.
Releasing the knob too fast. The thermocouple needs 30 to 60 seconds of flame contact to generate enough current. If you let go after five seconds, the pilot dies and you assume the part is bad. Try again and hold longer.
Skipping the five-minute wait. This is the one that actually scares us. Gas accumulates in the combustion chamber during that window. Relighting too soon can cause a flash fire or a small explosion. Five minutes, every time.
Using a lighter instead of the igniter. On a unit with a working piezo igniter, use it. Reaching a flame into the burner compartment puts your hand and face near the gas port.
Relighting over and over. If the pilot dies three times in a row, the problem is not the reset procedure. It is a part. Stop and call.
Ignoring the water temperature setting. A lot of homeowners crank the thermostat to 160°F to "fix" short hot water. That is a scald hazard, especially with kids in the house. 120°F to 130°F is the right range for most Littleton homes.
Not flushing the tank. Annual flushing removes the sediment that shortens thermocouple life. It is a 30-minute job and it adds years to the tank. If you have never had it done, that is a good reason to schedule water heater repair Littleton CO before the pilot issue becomes a tank replacement.
When to Call a Professional
Call a plumber when the pilot will not stay lit after two clean reset attempts, when you smell gas, when you see water pooling under the tank, or when the unit is over 10 years old and this is the second or third failure this year. Those are the four situations where a DIY relight turns into a bigger problem.
We handle pilot light repairs on every major brand - Rheem, A.O. Smith, Bradford White, State, and Navien. Most thermocouple and thermopile replacements are done in a single visit, usually under 90 minutes. If the gas valve is the issue, we will tell you straight whether the repair makes sense or whether you are better off putting that money toward a new unit.
If your tank is on its last legs and you are weighing repair versus replacement, we can walk you through the numbers on water heater installation Littleton CO and what a modern high-efficiency unit would cost in 2026. For homes with limited utility space or high hot water demand, tankless water heater installation Littleton CO is worth a conversation - the upfront cost is higher, but the unit lasts roughly twice as long and there is no standing pilot to fail.
We serve the whole Littleton area, from the older homes near Downtown Littleton Plumber Littleton CO to newer builds out toward Roxborough Plumber Littleton CO. Same-day service is available most weekdays, and we carry common thermocouples and thermopiles on every truck so most repairs are finished in one trip.
Frequently Asked Questions
How do I reset my water heater pilot light in Littleton CO?
Turn the gas knob to OFF, wait five minutes, set the knob to PILOT, hold it down, and press the igniter. Keep holding for 30 to 60 seconds after the flame catches, then release and turn to ON. Hot water returns in about 30 to 45 minutes for a 40-gallon tank.
Why does my water heater pilot light keep going out in Littleton?
The most common cause is a worn thermocouple or thermopile, which fails after 5 to 8 years. Other causes include a dirty pilot orifice, downdrafts from our foothills wind patterns, altitude-related combustion issues, and a failing gas valve. Two or more failures in a month means a part is failing.
Is it safe to reset a water heater pilot light in Littleton?
Yes, if you shut the gas off first, wait the full five minutes, and never relight when you smell gas. Do not attempt it if you see standing water, scorch marks, or soot near the burner. Those are signs of a bigger problem that needs a licensed plumber.
When should I call a plumber for a pilot light in Littleton?
Call after two failed reset attempts, any time you smell gas, if you see water under the tank, or if the unit is over 10 years old and failing repeatedly. Typical thermocouple replacement runs $150 to $250 in 2026, including the part and labor.
How much does water heater pilot light repair cost in Littleton CO?
Thermocouple or thermopile replacement typically runs $150 to $250 in 2026. A gas valve replacement runs $250 to $450. If the tank is over 12 years old, replacement often makes more financial sense than another repair.
Get Help with Plumber Littleton CO in Littleton
If your pilot light will not stay lit, or you would rather not deal with it yourself, our team handles pilot light repairs across Littleton seven days a week. We diagnose the actual cause, quote the repair upfront, and get your hot water back the same day in most cases.
Call +1 (831) 293-1204 to schedule service. We serve every Littleton neighborhood, from Downtown to Roxborough, and we carry the common parts on the truck so most jobs are done in one visit.